How To Repair A Bar Sink Drain

Have you ever needed to know How to Replace a Sink Bleed? Or peradventure in the past y'all hired a plumber. Well, I'1000 here today to tell you that it's not a hard projection and I know you can practice it!

I retrieve the plumbing Gods smiled down on me recently. Later on the little leak that turned into a major kitchen renovation, finding this cleft in the drain pipage saved usa from another plush leak.

I don't normally audit the drain pipes on our sinks, simply I just happen to exist looking for something under my sons' sink when I noticed the crevice on the drain pipe. Remarkably, at that place were no drips in the vanity. Before I could grab a new bleed assembly, I gently hinted to the family that they might want to utilize another sink in the business firm. (I'yard subtle, aren't I.)

Replacing a Sink Drain Materials:

(contains chapter links)

Replacing a Sink Drain Instructions:

Lay out a towel under your sink to catch any drips and to cushion your work area.

Reach behind your bleed and unscrew the cap around the popular-up ball and rod. Remove them from the drain. (FYI, if y'all e'er have a broken pop-upwards, y'all tin fix your pop-up stopper with this tutorial.)

Remove the stopper from the drain.

Look under the sink and locate the P-trap. Loosen the slip basics from the p-trap near the wall and on the drain. (For more details, you can encounter this tutorial for removing the p-trap.)

Pull the P-Trap down to release information technology from the drain. Dump any excess h2o and gunk into a bowl.

The tailpiece on my bleed assembly was plastic and only crumbled in my manus (that'due south why it looks like I skipped alee.)

Utilize your pliers to loosen the nut on the drain and remove it. If the nut is stuck, spray a piddling WD-twoscore on it and expect virtually 10-15 minutes.

Pull the rubber gasket from the bottom of the drain.

Reach on summit into the sink and lift upwardly the drain flange.

Preparing the new drain:

Remove the new drain associates from the package.

Utilise teflon tape to every threaded section of the drain associates:

Effectually the tailpiece (top and anywhere else you see threads.)

Effectually the Pop-up Brawl & Rod seat.

Around the P-trap.

Remove the one) stopper and 2) flange neckband.

Slide the slip nut and washer from the p-trap onto the drain tailpipe.

Insert the flange collar into the top of the sink (I didn't apply plumbers putty under the flange because there was a gasket that fit under the collar, but your directions may call for plumber's putty. Be sure to follow the directions for your specific drain installation.) The remainder of the bleed assembly is inserted into the sink through the lesser.

Tighten the nut on the underside until the gasket begins to spread and the drain associates is snug in the sink.

Slide the p-trap onto the tailpiece of the drain.

Fit the back of the p-trap into the waste pipe going into the wall. Tighten both skid nuts with your hands.

I ordinarily turn all nuts an additional 1/4 – one/2 turn with pliers because I'm not a strong hand tightener.

Follow my instructions for re-installing the stopper if you need help getting it seated properly.

Run the water and look underneath for leaks. Fill up the sink basin full and permit it sit down for a infinitesimal.

Bank check underneath for whatsoever signs of water. Tighten the nut if you practise run across any drips. Make sure y'all accept enough teflon tape on the threads.

Your sink should be ready for use now!

Pin for later!

Source: https://www.prettyhandygirl.com/replacing-a-sink-drain/

Posted by: creasyotatew.blogspot.com

Share this post